Synthetic blood penetration tester manufacturer from China? Universal strength tester by using different clamps, it can be widely used for determining tensile strength, elongation, tear force, adhesive force, tensile stress, peeling strength, shearing force, etc. of the completed products, semi-completed products or dumbbell-type specimens of various materials such as sole, tire, rubber tube, triangle adhesive tape, plastic cloth, plastic plate, metal, packaging film, Acrylic, FRP, ABS, EVA, PV etc. Fiber tensile strength test machine is driven by the AC servo motor, through the synchronous belt and synchronous wheel drives the ball screw rotate, to make the beam up and down, after stretching or compressing the sample by the analysis of force sensor data from a computer system. Discover additional information on splash resistance tester.
Mask Testing Machine Synthetic Blood Penetration Tester, Bacterial Filtration Efficiency Test Equipment, Particulate Filtration Efficiency Tester, Masks Leakage Tester In stock, fast delivery, Consult us now! Mask testing equipment produced by GESTER is very popular in the market.Protective Clothing Tester and Mask Tester, manufactured based on high-quality materials and advanced technology, has reasonable structure, excellent performance, stable quality, and long-lasting durability. It is a reliable product which is widely recognized in the market.Adhering to the service concept to be customer-oriented and service-oriented, GESTER is ready to provide our clients with quality products and professional services.
Testing to ASTM D4060 involves mounting a flat specimen to a turntable that rotates horizontally at a fixed speed. Two arms, each supporting an abrading wheel, are then lowered so that each wheel touches the surface. Before starting the test, a “suction arm” is lowered between the wheels to remove the abraded material from the sample’s surface. The turntable then starts rotating forcing rub-wear action of the wheels against the sample’s surface for the specified number of cycles or until a given mass of coating has been lost or until the wheels start exposing the substrate.
Correct use of computerized universal testing machine: When the electronic stepless speed regulation adjusts the lifting speed, it cannot be operated too fast. Before using the 50KN power machine, pay attention to check the tightening of the clamp tightening screws. When lifting the lower clamp, the movement should be stable, avoid collision, and often check the tightness of the clamp screw. When replacing the test fixture, pay attention to cooperate to prevent bruises.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test.
Pneumatic Bursting Strength Testing Machine For determining the bursting strength of woven or knitted fabrics, non-woven, paper, leather and board by application of a pneumatic load under a rubber diaphragm of a specific area. Provide with a digital readout of pressure with peak value hold facility, renewable rubber diaphragms, and manual clamping device with acrylic bell, forward reverse and neutral drive system. Provide accurate elongation information of fabrics, up to 0.1mm. Discover more details at gesterinstruments.com.